We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
You get a straight answer on cost up front, with every line explained and nothing hidden.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
Most people who call us have never dealt with bathroom water damage before. We walk you through it on the phone, then send a local crew with the right equipment.
Bathrooms are built to get wet on the surface, not underneath it. When caulk cracks, grout wears thin or a toilet seal fails, a little water slips past with every shower and every flush. It collects in the subfloor and the wall behind the tile, out of sight. Our Fullerton team finds where the water is getting in, measures how far it has gone, and dries or removes what is wet.
These leaks are usually slow, so the damage is often deeper and older than it appears. Subfloor under a toilet can be soft all the way through while the tile above still looks fine. We use moisture meters and thermal imaging to map the wet area without tearing out more than we need to, then open only the sections that cannot be dried in place.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Ask a Tech: (810) 440-6679| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Tile backer board | Cement board that is wet but intact and free of mold | Drywall or green board behind tile that has turned soft |
| Sheet vinyl flooring | Sealed seams, tight edges, and water that never got below | Curling, lifting or stained vinyl, or any water trapped below it |
| Ceiling below | Just a small stain, and the drywall is firm and flat | Sagging, crumbling, or soaked through from the bathroom above |
| Vanity cabinet | Briefly wet cabinets built from solid wood or plywood | Swollen, split or moldy particleboard |
| Baseboards and door casing | Solid wood trim that dries flat with no mold behind it | Swollen fiberboard trim, or anything wet by a toilet overflow |
With every shower, the bad caulk or grout lets a small amount of water through. Backer board and the outer rim of the subfloor take it in, and there is still nothing to see.
The wood under the tile never gets a chance to dry between showers. Within the wall cavity, and across the bottom of the floor, mold begins.
You see darker grout, loosening tiles and blackened caulk. Where a room sits underneath, its ceiling develops a stain that gradually spreads.
Joists can begin to rot, and the subfloor near the toilet or tub becomes soft. Drying alone no longer fixes it, because carpentry and new tile are now part of the repair.
Each fixture is tested separately, from the supply lines to the toilet, tub and shower, and thermal imaging and moisture meters show us where water went beneath tile and in the walls.
Loose tile, rotted subfloor and soft wall board come out. If the toilet was the source, we handle that section as contaminated, and porous materials we cannot clean go.
Air movers and dehumidifiers dry the subfloor, the wall framing and the ceiling space below. We apply antimicrobial treatment and confirm dry readings before anything is closed up.
New subfloor and backer board go in, and we can coordinate the tile, toilet seal, caulk and ceiling work, meaning the path of the leak gets closed and not just hidden.
Before dripping, water runs along joists and pipes, which can put the downstairs stain several feet away from the real leak. Wiring and light fixtures may lie along that route.
Every use of the shower sends water beneath its floor when the pan or liner is cracked. Framing under the shower stays saturated even though the surface shows no flaw.
When the wax ring gives out, a bit of water escapes every time the toilet is flushed. The water is category 3, and it rots the subfloor around the flange until the toilet starts to rock.
Behind the towels and bottles kept under the sink, a drain fitting or supply valve can drip for months. The cabinet floor swells, and the water runs through to the subfloor and the wall behind it.
Have a different question? Call us and we will answer it over the phone.
Call (810) 440-6679Take action now and prevent costly damage. Fullerton Restoration is ready to help.
Call (810) 440-6679 Now