We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
The quote is free and you see the price before work begins. No surprise charges at the end.
Call now and a real person picks up. We ask a few questions and send a crew, so the water stops spreading sooner.
When you call about wall and drywall water damage, you reach a restoration team that works in Fullerton every day. We tell you what it will take, give you a clear quote and get a crew moving.
A sheet of drywall behaves much as a wick does. When water reaches the bottom of a wall, the gypsum and paper draw it upward, often a foot or more above the level the water ever reached on the floor. The painted face can look and feel normal while the back side and the insulation behind it are soaked. For that reason our team relies on moisture meter readings rather than appearance.
Not every wet wall has to be torn out. When the water was clean and the drywall remains firm, drying it where it stands is often possible, at times by pulling the baseboard and pushing air into the cavity through small holes. If the drywall has gone soft, crumbles, shows mold or took in dirty water, we do a flood cut, meaning a level cut over the damaged area with all material beneath it removed.
Water at the base of the wall soaks into the drywall edge and starts to climb. Baseboards and the bottom plate take on moisture.
Moisture keeps climbing, the baseboards puff up and blisters form in the paint. Growth is able to get going on the paper that lines the hidden side.
The gypsum core turns soft and its paper starts to separate. A musty odor grows stronger while the batts settle and mold covers more of the unseen face.
By this point the studs and plates have been damp long enough for mold and early rot. Much more wall now has to be removed and rebuilt.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Call (810) 440-6679| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Wall studs | Nearly all framing, because sound wood dries in open air | Only where rot or heavy mold has damaged the wood |
| Baseboards and trim | Real wood pieces that stay straight and uncracked after drying | Swollen MDF and trim with edges that are flaking apart |
| Wall insulation | Closed cell foam that does not absorb water | Fiberglass and cellulose that got wet, because they slump and hold moisture |
| Drywall | Panels that stay hard and true after a short clean water event | Soft, swollen, moldy, or wet from gray or black water |
| Paint and wallpaper | Paint that stays bonded on a wall that dried flat | Peeling paint and vinyl paper holding dampness against the wall |
We scan each wall with a moisture meter and thermal camera and mark how high and how far the water traveled, including the opposite side and adjoining rooms.
Based on the water category, how long it sat and how the drywall feels, we tell you plainly which sections can be dried in place and which need to come out.
Where the drywall stays, the trim is pulled and airflow is sent inside the wall. Walls that cannot be kept get a flood cut along a level line, with the wet insulation pulled.
Air movers and dehumidifiers run until studs and remaining drywall read dry, typically 3 to 5 days. The rebuild follows with fresh insulation, drywall installation and finishing, trim and a coat of paint.
Fiberglass batts soak up water and hold it against the studs. No amount of airflow on the painted side will dry a cavity packed with wet batts.
On an exterior wall, water can soak the sheathing behind the insulation. Because it is slow to dry, we test it before any new drywall goes up.
Paper lining, darkness and stagnant air make the hidden side of a wall a perfect place for mold. It can cover the hidden side while the painted face looks clean.
Water pools at the same height as most receptacles and cable runs. Until that circuit is inspected, avoid plugging anything into the affected wall.
Have a different question? Call us and we will answer it over the phone.
Call (810) 440-6679Take action now and prevent costly damage. Fullerton Restoration is ready to help.
Call (810) 440-6679 Now